Cisco WLC 5700 Series Interface Configuration Manual page 27

Using the Web Graphical User Interface
When you log in for the first time, the Accessing Cisco Controller <Model Number> <Hostname> page appears.
Step 3 On the Accessing Cisco Controller page, click the Wireless Web GUI link to access controller web GUI Home page.
Step 4 Choose Configuration > Wizard to perform all steps that you need to configure the controller initially.
The Admin Users page appears.
Step 5 On the Admin Users page, enter the administrative username to be assigned to this controller in the User Name text box
and the administrative password to be assigned to this controller in the Password and Confirm Password text boxes.
Click Next.
The default username is admin and the default password is cisco. You can also create a new administrator user for the
controller. You can enter up to 24 ASCII characters for username and password.
The SNMP System Summary page appears.
Step 6
On the SNMP System Summary page, enter the following SNMP system parameters for the controller, and click Next:
• Customer-definable controller location in the Location text box.
• Customer-definable contact details such as phone number with names in the Contact text box.
• Choose enabled to send SNMP notifications for various SNMP traps or disabled not to send SNMP notifications
for various SNMP traps from the SNMP Global Trap drop-down list.
• Choose enabled to send system log messages or disabled not to send system log messages from the SNMP Logging
drop-down list.
Note The SNMP trap server, must be reachable through the distribution ports (and not through the gigabitethernet0/0
service or management interface).
The Management Port page appears.
Step 7 In the Management Port page, enter the following parameters for the management port interface (gigabitethernet 0/0)
and click Next.
• Interface IP address that you assigned for the service port in the IP Address text box.
• Network mask address of the management port interface in the Netmask text box.
• The IPv4 Dynamic Host Configuration Protocol (DHCP) address for the selected port in the IPv4 DHCP Server
text box.
The Wireless Management page appears.
Step 8 In the Wireless Management page, enter the following wireless interface management details, and click Next.
• Choose the interface—VLAN, or Ten Gigabit Ethernet from the Select Interface drop-down list.
• VLAN tag identifier, or 0 for no VLAN tag in the VLAN id text box.
• IP address of wireless management interface where access points are connected in the IP Address text box.
• Network mask address of the wireless management interface in the Netmask text box.
• DHCP IPv4 IP address in the IPv4 DHCP Server text box.
When selecting VLAN as interface, you can specify the ports as –Trunk or Access ports from the selected list displayed
in the Switch Port Configuration text box.
OL-32314-01
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
Configuring the Controller Web GUI
17