Finding Feature Information - Cisco WLC 5700 Series Interface Configuration Manual

Finding Feature Information

•
•
•
•
•
•
•
•
•
•
•
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release. Use Cisco Feature
Navigator to find information about platform support and Cisco software image support. To access Cisco
Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not required.
Pre-requisites for Configuring Interfaces
You can define the wireless management, AP-manager, virtual, and management interface parameters using
the Startup Wizard. However, you can display and configure interface parameters through either the GUI or
CLI after the controller is running.
For Cisco 5700 Series Controllers in a non-link-aggregation (non-LAG) configuration, the management
interface must be on a different VLAN than any dynamic AP-manager interface. Otherwise, the management
interface cannot fail over to the port that the AP-manager is on.
To configure interfaces, you must configure the default gateway, router, and the IP route using the following
commands:
• ip default-gateway 154.4.0.1
• default-router 154.51.0.1
• ip route 0.0.0.0 0.0.0.0 154.4.0.1
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
22
Configuring and Using Interface Range Macros: Examples, page 34
Configuring Interfaces, page 35
Configuring Layer 3 Interfaces, page 36
Shutting Down and Restarting the Interface, page 37
Monitoring Interface Characteristics, page 39
Monitoring Interface Status, page 39
Clearing and Resetting Interfaces and Counters, page 40
Viewing Wireless Interfaces (GUI), page 40
Configuring Ports (GUI), page 41
Configuring Wireless Interface (GUI), page 42
Feature History and Information For Configuring Interfaces, page 43
Configuring Interfaces
OL-32314-01