Cisco WLC 5700 Series Interface Configuration Manual page 12

Command Modes
Table 1: Command Mode Summary
Mode
User EXEC
Privileged EXEC
Global
configuration
VLAN
configuration
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
2
Access Method Prompt
Begin a session
Controller>
using Telnet, SSH,
or console.
While in user
Controller#
EXEC mode, enter
the enable
command.
While in privileged
Controller(config)#
EXEC mode, enter
the configure
command.
While in global
Controller(config-vlan)#
configuration
mode, enter the
vlan vlan-id
command.
Using the Command-Line Interface
Exit Method About This Mode
Enter logout or Use this mode to
quit.
• Change
terminal
settings.
• Perform basic
tests.
• Display system
information.
Enter disable Use this mode to
to exit. verify commands
that you have
entered. Use a
password to protect
access to this mode.
Use this mode to
execute privilege
EXEC commands
for access points.
These commands are
not part of the
running config of the
controller, they are
sent to the IOS
config of the access
point.
To exit to Use this mode to
privileged configure parameters
EXEC mode, that apply to the
enter exit or entire controller.
end, or press
Use this mode to
Ctrl-Z.
configure access
point commands that
are part of the
running config of the
controller.
OL-32314-01