Cisco WLC 5700 Series Interface Configuration Manual page 28

Configuring the Controller Web GUI
The RF Mobility and Country Code page appears.
Step 9 In the RF Mobility and Country Code page, enter the RF mobility domain name in the RF Mobility text box, choose
current country code from the Country Code drop-down list, and click Next. From the GUI, you can select only one
country code.
Before configuring RF grouping parameters and mobility configuration, ensure that you refer to the relevant
Note
conceptual content and then proceed with the configuration.
The Mobility Configuration page with mobility global configuration settings appears.
Step 10 In the Mobility Configuration page, view and enter the following mobility global configuration settings, and click Next.
• Displays Mobility Controller in the Mobility Role text box.
• Displays mobility protocol port number in the Mobility Protocol Port text box.
• Displays the mobility group name in the Mobility Group Name text box.
• Displays whether DTLS is enabled in the DTLS Mode text box.
DTLS is a standards-track Internet Engineering Task Force (IETF) protocol based on TLS.
• Displays mobility domain identifier for 802.11 radios in the Mobility Domain ID for 802.11 radios text box.
• Displays the number of members configured on the controller in the Mobility Domain Member Count text box.
• To enable the controller as a Mobility Oracle, select the Mobility Oracle Enabled check box.
Only the controller can be configured as Mobility Oracle. You cannot configure the switch as Mobility
Note
Oracle.
The Mobility Oracle is optional, it maintains the client database under one complete mobility domain.
• The amount of time (in seconds) between each ping request sent to an peer controller in the Mobility Keepalive
Interval (1-30)sec text box.
Valid range is from 1 to 30 seconds, and the default value is 10 seconds.
• Number of times a ping request is sent to an peer controller before the peer is considered to be unreachable in the
Mobility Keepalive Count (3-20) text box.
The valid range is from 3 to 20, and the default value is 3.
• The DSCP value that you can set for the mobility controller in the Mobility Control Message DSCP Value (0-63)
text box.
The valid range is 0 to 63, and the default value is 0.
The WLANs page appears.
Step 11 In the WLANs page, enter the following WLAN configuration parameters, and click Next.
• WLAN identifier in the WLAN ID text box.
• SSID of the WLAN that the client is associated with in the SSID text box.
• Name of the WLAN used by the client in the Profile Name text box.
The 802.11 Configuration page appears.
Step 12
In the 802.11 Configuration page, check either one or both 802.11a/n/ac and 802.11b/g/n check boxes to enable the
802.11 radios, and click Next.
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
18
Using the Web Graphical User Interface
OL-32314-01