Configuring Ap Join In An Ap Manager Interface - Cisco WLC 5700 Series Interface Configuration Manual

Configuring AP Manager Interfaces

Configuring AP Join in an AP Manager Interface

Before You Begin
The controller sends the access point a CAPWAP join response allowing the access point to join the controller.
When the access point joins the controller, the controller manages its configuration, firmware, control and
data transactions.
When an access point performs a reboot or is disconnected from the controller, the join statistics for an access
point is maintained from the controller. But this statistics are lost when the controller performs a reboot or
disconnects.
SUMMARY STEPS
1. conf t
2. wireless ap-manager interface vlan vlan-ID
3. end
DETAILED STEPS
Command or Action
Step 1
conf t
Step 2
wireless ap-manager interface vlan
vlan-ID
Step 3
end
Viewing Configured Access Point Join Management Interfaces
Before You Begin
You can view the access point join interfaces configured in the controller using the following steps:
SUMMARY STEPS
1. show ap summary
2. show ap name
3. show ap name apname config general
4. show wireless interface summary
OL-32314-01
Purpose
Enters global configuration mode.
Enables the access point to receive the IP address and join the
specified VLAN.
Maps the AP manager to the selected interface.
Returns to EXEC mode.
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
Configuring AP Join in an AP Manager Interface
53