Menu Structures And Parameter Descriptions - Rice Lake 320IS Plus Installation Manual

Four front panel keys are used as directional keys to navigate through the menus in setup mode (see Figure 3-2).
The ( ) and
UNITS PRINT
( ) move up and down (vertically) to different menu levels. The
GROSS/NET
for selecting parameter values within the menus. A label above each of these keys identifies the direction
provided by the key when navigating through the setup menus.
1 Level
st
Parameter
2 nd Level
Parameter
Default value
When moving through values below the first menu level, press
above. Pr e ss or
To select a parameter, press
right until the desired menu group appears on the
display, then press to move down to the submenu or
parameter you want. When moving through the menu
parameters, the default or previously selected value
appears first on the display.
To change a parameter value, scroll left or right to
view the values for that parameter. When the desired
value appears on the display, press
value and move back up one level. To edit numerical
values, use the navigation keys to select the digit and
to increment or decrement the value or use the
numeric keypad (see Figure 3-4).
3.2

Menu Structures and Parameter Descriptions

The following sections provide graphic representations of the
structure, the settings you choose under each parameter are arranged horizontally. To save page space, menu
choices are shown in vertical columns. The factory default setting appears at the top of each column.
Most menu diagrams are accompanied by a table that describes all parameters and parameter values associated
with that menu. Default parameter values are shown in bold type.
To exit configuration mode, with the display showing
( ) keys scroll left and right (horizontally) on the same menu level;
Value
Value
to move to the next parameter on the level above.
Figure 3-3. Setup Mode Menu Navigation
or to scroll left or
to select the
TARE
Value
to return to the level
0 0 0 0 0 0
When editing numeric values, press
digit selected. Press
value of the selected digit, or use the numeric keypad.
Press to save the value entered and return to the level above.
Figure 3-4. Editing Procedure for Numeric Values
320IS Plus menu structures. In the actual menu
., press the ZERO key to scroll up.
CONFIG
( ) and
ZERO
key ( ) serves as an enter key
1 Level
st
Parameter
nd
2 Level
Parameter
or to change th e
or to increment or decrement the
Configuration 15