Solid-State Drive - HP Spectre x360 13 Maintenance And Service Manual

Solid-state drive

Description
2-TB, M.2 2280/DS, SATA-3, PCIe, NVMe, solid-state drive with TLC
1-TB, M.2 2280/DS, SATA-3, PCIe, NVMe, solid-state drive with TLC
512-GB, M.2 2280/DS, SATA-3, PCIe, NVMe, solid-state drive with TLC
360-GB, M.2 2280/DS, SATA-3, PCIe, NVMe, solid-state drive with TLC
256-GB, M.2 2280/DS, SATA-3, PCIe, NVMe, solid-state drive with TLC
128-GB, M.2 2280/DS, SATA-3, PCIe, NVMe, solid-state drive with TLC
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×2.8 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the solid-state drive.
Bottom cover on page
Solid-state drives are designed with notches to prevent incorrect insertion.
29).
Battery on page 31).
Component replacement procedures
Spare part number
L04986-001
941878-001
941881-001
941880-001
941879-001
941877-001
33