Table of Contents
Advertisement
• Close the terminal program and switch the reflow controller off.
• Start the program "Megaload.exe" and the following window will open:
• Set the parameters as shown in the diagram.
Please ensure that you only use the source files provided by us.
Please ensure that the checkbox "Eeprom programming" is always ticked.
Check again that you have made a note of your own parameter settings.
Check again that you have selected the correct files for programming.
• Power on the controller and programming will commence immediately.
It is important that you do not interrupt this process.
Reflow Controller V3 PRO
Operating Instructions
Page 35 of 39
Advertisement
Table of Contents
Need help?
Do you have a question about the Reflow-Kit V3 PRO and is the answer not in the manual?
Questions and answers