Software Update Instructions - Beta Layout Reflow-Kit V3 PRO Operating Instructions Manual

Command
Manual
shot

10 Software update instructions

The software can be updated via the controller's USB interface. To do this, you will need
the following:
• A PC with a USB interface and Windows operating system.
• A standard USB cable.
• The software "Megaload" (available for download on www.beta-eSTORE.com/RKCV3).
Thanks to Sylvain Bissonette (www.microsyl.com), who kindly made this software availa-
ble to us.
Start by unzipping the files into your designated directory.
The software can also be run directly from a host, in which case separate installation is
not required.
Connect the controller to the USB port on your PC. If you have not yet configured the
PC connection for the controller, please do so by following the instructions in the chapter
"Setting parameters via the computer".
• Test the PC connection with an appropriate terminal program.
• Make a note of your own controller settings (parameter sets).
Parameter Definition
Switch controller to manual mode
Manual 0<enter> End manual mode,
controller is switched to normal mode.
Manual 1<enter>
Switch controller to manual mode.
0 .. 100] % Single pulse with heat capacity X
shot X<ENTER> Release single heat pulse X%.
WARNING!
This command will only work if the controller has
already been switched to manual mode.
Reflow Controller V3 PRO
Operating Instructions
Page 34 of 39