Initial Installation; For A Base Station Set Up - Alinco DR-135TMkIII Instruction Manual

3. Initial Installation

Connect the microphone to the front panel of the transceiver.
Connect antenna port to a 50 ohm antenna that is tuned to the band, using good quality 50 ohm
coaxial cable.
External speaker
(if used)

For a base station set up

The Transceiver requires a 12-13.8VDC negative grounded power source.
Use a regulated power supply capable of providing continuous current of 12A or more.
Power supplies that do not meet those specifications may cause malfunction and/or damage to the
radio and will void the warranty. Alinco offers excellent communication-grade power supplies as
optional accessories. Please contact your local authorized Alinco dealer.
DC
power supply
CAUTION: The body (heatsink) of this product may become very hot during/after the operation.
Never touch the unit until it cools down.
* When a transceiver is powered from an external DC power source (adapter, power supply, cigar-
plug etc), make sure that this power supply has approval to the level of IEC/EN 60950-1.
Microphone
rear panel
(T/E models only)
*
2
Red lead
Black lead
1
Antenna
DC power cable
11