Getting Started - Snom C520-WiMi User Manual

Getting Started

Connecting
The C520-WiMi can be powered by AC power or Power over Ethernet (PoE). If PoE is not
available, use AC power, as shown below.
Note: the conference phone requires a network connection to an IP PBX to operate.
This manual assumes that your network infrastructure is established and that your
IP PBX phone service has been ordered and configured for your location.
1. Plug one end of the DC power cable into the power jack of the phone, and plug the
other end into the yellow C520-WiMi jack of the power adapter. Route the cord
through the slots.
2. Plug one end of the Ethernet cable into the LAN jack of the power adapter, and plug
the other end into a network switch or router.
3. Plug the small end of the AC power cord into the power jack of the adapter, and
plug the large end into a wall outlet not controlled by a switch.
• The supplied power adapter is designed for use with only the Conference phone . It
is not designed to power other network devices. Do not connect the supplied power
adapter to any other network devices through the supplied DC power cable or any
other Cat5e ethernet cable.
• The AC power cord is intended for a vertical or floor mount position. The prongs are
not designed to hold the plug in place if it is plugged into a ceiling or cabinet outlet.
To Adapter
Slots
1
DC power cable
(with yellow plugs)
Slots
Ethernet cable
3
Adapter
2
Ethernet cable
Network switch
or router
Battery X2
Wall outlet
3
AC power cord
Network switch
or router