Advertisement
Presence detector and motion detector 360° compact
Saving the current brightness as the switch-on brightness
o
Press the Ų button for longer than 10 seconds.
The current brightness is saved as the switch-on brightness.
Adjusting the run-on time
The run-on time is set during commissioning. The run-on time can be adjusted at a later time
using the supplied IR remote control.
o
Press Time button briefly.
o
Within 10 seconds, press the Ű or ű button briefly.
Each button press extends or shortens the run-on time by 10 % of the set value, but by at
least 1 Lux.
Recalling saved settings
During commissioning, the installation engineer can save the settings made (see Saving
settings). These can be recalled if, for example, changes made later are no longer required.
o
Press the Set 2 button for longer than 10 seconds.
Settings saved by the installation engineer are active again.
Switching the presence simulation on or off
o
Press the ų button for longer than 10 seconds.
The presence simulation is switched on or off alternately. If the function is switched on, the
red LED flashes slowly.
i The function cannot be activated until 24 hours after first commissioning.
5 Information for electrically skilled persons
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before carrying out work on the device or load, disengage all the
corresponding circuit breakers. Cover up live parts in the working environment.
5.1 Fitting and electrical connection
Detection field and range
82593212
Figure 3: Tangential and radial direction of motion
12.01.2017
6/18
Advertisement
