Advertisement
Presence detector and motion detector 360° compact
Switch on test operation
The test operation is used for testing the detection area. In test operation, the device operates
independently of the brightness. All the other settings remain unchanged. Detected motions are
signalled by the blue status LED.
o
Press the Test 100 h button for between 4 and 10 seconds.
Test operation is switched on for 5 minutes.
i By pressing the ů button of the IR remote control for end customers, you can
switch to automatic operation at any time (see Operation).
i The function is also switched off if the Reset button is pressed for between 4 and
10 seconds.
Switch On for 100 h
This function is used to burn in fluorescent lamps.
o
Press the Test 100 h button for longer than 10 seconds.
The lamps are switched on for 100 hours. The device is switched back to automatic
operation again after the time has elapsed.
i During the 100 hours, no switching is possible via 2-wire extension, installation button or IR
remote control, movement signals are not evaluated.
i To switch off the function, press the Reset button for between 4 and 10 seconds.
Saving settings
Save the settings so that, if necessary, the end customer can recall them using the Set 2
button. No values are saved in the as-delivered state.
o
Press the Set 1 button for longer than 10 seconds.
The following settings are saved: Device function, sensitivity of PIR A-C, detection angle,
switch-on brightness, run-on time, dynamic run-on time, short-time operation, switch-off
prewarning. Previously saved values are overwritten.
Restoring the device to factory settings
o
Press the Reset button for longer than 10 seconds.
Function
Device function
Operating mode
Sensitivity of PIR A-C
Detection angle
Switch-on brightness
Run-on time
Dynamic run-on time
Short time operation
Switch-off warning
Presence simulation
Test operation
i If the Reset button is pressed for between 4 and 10 seconds, only a few functions are
terminated (see button assignment of Installation engineer IR remote control).
6 Appendix
82593212
Value
Motion detector
Automatic operation
100 %
360°, PIR A-C switched on
10 lux
2 minutes
switched-off
switched-off
switched-off
switched-off
switched-off
12.01.2017
15/18
Advertisement
