Advertisement
Presence detector and motion detector 360° compact
o
Using scissors, cut out push-on cover along the marked lines as required.
o
Push on push-on cover.
i Alternatively, the detection area can also be limited by switching off individual sensors (see
Commissioning).
5.2 Commissioning
Insert battery into IR remote control
i To avoid contact problems, keep the contacts of batteries and device free of grease.
CAUTION!
Risk of chemical burns.
Batteries can burst and leak.
Replace batteries only with an identical or equivalent type.
o
Insert the supplied battery with correct polarity (see IR remote control imprint)
The operation and necessary settings are carried out using the IR remote control for the
installation engineer (see Accessories).
i If multiple devices are within the range of the IR remote control, then align it so that only
the device to be operated can receive the signals.
Button assignment of the installation engineer IR remote control
Button
1 s Ů
30 s Ů, 2 min Ů, 5 min Ů, 30 min Ů
ũ
Pressing for longer than 10 seconds
Ê, Ŧ, ŧ, Ũ
0-1 hŮ
Dyn.Ů Pressing for longer than 10 seconds
PIR A, PIR B, PIR C, PIR A-C Pressing for
longer than 10 seconds
PIR A, PIR B, PIR C
Pressing for less than 10 seconds
25 %, 50 %, 75 %, 100 %
Ū
Pressing for longer than 10 seconds
ū
Pressing for longer than 10 seconds
Ŭ
Test 100 h
Pressing for less than 10 seconds
Test 100 h
Pressing for longer than 10 seconds
Set 1
Pressing for longer than 10 seconds
82593212
Function
Short time operation
Set run-on time
Saving ambient brightness as brightness
threshold
Setting the brightness threshold
Setting individual run-on time
Switching on the dynamic run-on time
Switching the PIR sensors on/off
In the next 5 seconds, use the 25 %, 50 %, 75
% and 100 % buttons to set the sensitivity of
the appropriate PIR sensor
Setting the sensitivity
Switching on the Presence detector device
function
Switching on the Motion detector device
function
No function is saved for this device
Switch on test operation
On for 100 hours
Save any changes made for later recall using
the Set 2 button of the end customer IR
remote control
12.01.2017
12/18
Advertisement
