Advertisement
Presence detector and motion detector 360° compact
Off
On
Flashing slowly
Flashing
Off
Button assignment of the end user IR remote control
Button
ů
Pressing for less than 0.4 seconds
ů
Actuation of between 1 and 4 seconds
Ű
Pressing for less than 0.4 seconds
ű
Pressing for less than 0.4 seconds
2 h On
Pressing for less than 0.4 seconds
2 h Off
Pressing for less than 0.4 seconds
Ų
Pressing for less than 10 seconds
Ų
Pressing for longer than 10 seconds
Set 2
Pressing for longer than 10 seconds
ų
Pressing for longer than 10 seconds
Time
Pressing for less than 10 seconds
Switching on light for the duration of the run-on time
A 2-wire extension or an installation button is connected.
i In short-time operation, cyclic pulses take place whilst the 2-wire extension at top or bottom
or installation button is pressed.
i Alternatively, press the ů button of the IR remote control for between
1 and 4 seconds. In short-time operation, there is a single pulse after releasing the button.
Light is switched off.
Motion detector operation
o
Press the 2-wire extension or installation button for less than 0.4 seconds.
i If the 2-wire extension or the installation button is pressed again after switch-on, then the
run-on time is restarted.
Presence detector operation
82593212
On
Off
Off
Off
Flashing
Function
Switching on automatic mode
In automatic mode: Switch-on for the duration
of the run-on time
Continuous on
Continuous off
On for 2 hours
Off for 2 hours
In the next 10 seconds, the brightness
threshold can be changed incrementally using
the Ű or ű buttons.
Saving the current ambient brightness as the
brightness threshold
Activating the settings saved by the installation
engineer
Switching the presence simulation on or off
In the next 10 seconds, the run-on time can be
changed incrementally using the Ű or
ű buttons.
12.01.2017
Light switched on continuously
Light switched off continuously
or twilight button function
activated
Presence simulation switched
on
Receipt of IR signals
IR signal detected
4/18
Advertisement
