Advertisement
Presence detector and motion detector 360° compact
o
Press the top or full-surface of the 2-wire extension or installation button for less than
0.4 seconds.
Light is switched on depending on brightness and motion. Movements are evaluated
according to the brightness and prolong the run-on time.
Switching the light off for a period of 3 minutes
i This function can only be used in presence detector operation.
A 2-wire extension or an installation button is connected.
Light is switched on.
o
Press the bottom 2-wire extension or installation button.
The light is switched off for the period of 3 minutes. When movements are detected, the
time is restarted.
Switch on the light for 2 hours
Motions are not evaluated during this time. It is not possible to switch off via a 2-wire extension
or installation button.
o
Press 2 h On button of the IR remote control.
Light is switched on for 2 hours. The motion detector is in automatic operation again after
the 2 hours have elapsed.
i The time is restarted if actuation is repeated.
i Automatic operation is switched on again using the ů button.
Switch on the light continuously
Motions are not evaluated during this time. It is not possible to switch off via a 2-wire extension
or installation button.
o
Press the Ű button for shorter than 0.4 seconds.
Light is switched on continuously. The blue LED lights up.
i Automatic operation is switched on again using the ů button.
Switch off the light for 2 hours
Motions are not evaluated during this time. It is not possible to switch on via a 2-wire extension
or installation button.
o
Press the 2 h Off button.
Light is switched off for 2 hours. The device is in automatic operation again after the time
has elapsed.
i The time is restarted if actuation is repeated.
i Automatic operation is switched on again using the ů button.
Switch off the light continuously
Motions are not evaluated It is not possible to switch on via a 2-wire extension insert or
installation button.
o
Press the ű button for shorter than 0.4 seconds.
Light is switched off continuously. The red LED lights up.
i Automatic operation is switched on again using the ů button.
Adjusting the switch-on brightness
The switch-on brightness is set during commissioning. The switch-on brightness can be
adjusted at a later time using the supplied IR remote control.
o
Press Ų button briefly.
o
Within 10 seconds, press the Ű or ű button briefly.
Each button press extends or shortens the brightness threshold by 10 % of the set value,
but by at least 1 lux.
82593212
12.01.2017
5/18
Advertisement
