Printronix T5000e Series Module Manual page 52

Chapter 2
Configuring The Validator
6. Press ↵ to select the desired value.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Setting I2of5 Checksum
This option allows you to include or exclude the checksum option in
the Interleaved 2 of 5 code as part of the grading. For example, if
you enable this option, then any incoming bar code data without
checksum digits will be graded as a failure, and a Checksum
Failure error will display.
1. Press
Menu mode.
2. If necessary, press ↓ and ↵ at the same time to unlock the
↵ key.
3. If necessary, press
4. Press ↓ until "I2of5 Checksum" displays.
5. Press + or – to scroll through the options: Enable or Disable.
The default is Disable.
6. Press ↵ to accept the desired value.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Num Retry
This option allows you to set a number of retries for overstrike
before the printer stops.
The options are 3, 4, 5, and Infinite. The factory default is 5.
NOTE: This setting is utilized only if Validator Action is set to Retry
For the 3, 4, and 5 options, the printer will stop after the specified
number of retry attempts. After you clear the error message, the
printer will print the next label.
52
. .
to take the printer offline and place the printer in
.
. .
until "VALIDATOR" displays.
.
Form. See "Error Action" on page 62.