Printronix T5000e Series Module Manual page 32

Chapter 1
Adjust The Scanning Beam
Summary Of Scanning Beam Adjustment
To Move Beam
Down
Tighten top left Tighten both bottom
screw screws
or or
Loosen both Loosen top left screw
bottom screws
NOTE: If the printer does not have a tear bar with notches at the
Figure 16. Adjusting the Center of the Scanning Beam
32
To Move Beam To Rotate Beam
Up
Loosen bottom
right screw
or
Tighten bottom
left screw
ends, adjust the scanning beam so that the center of the
beam is approximately 0.06 inches (1.52 mm) from the
lower edge as shown in Figure 16.
0.06 inches
(1.52 mm)
To Rotate Beam
Clockwise Counterclockwise
Loosen bottom left
screw
or
Tighten bottom
right screw