Enable The Validator - Printronix T5000e Series Module Manual

Enable The Validator

Later version software can automatically detect the validator. When
the printer is powered up with the validator installed, the
VALIDATOR menu appears and Validator Funct. is automatically
set to Enable in the QUICK SETUP and VALIDATOR menus.
NOTE: You may need to load the Factory Config. in the CONFIG
With earlier software that cannot automatically detect the validator,
the default value for Validator Funct. is Disable so that printers
without validators do not stop and wait for the validator at boot up.
These printers with validators installed need to have Validation
Funct. set to Enable. This is a one-time setting if the save
configuration command is issued.
1. Press
2. If necessary, press ↓ and ↵ at the same time to unlock the
3. If necessary, press
4. Press ↓ until "Validator Funct." displays.
5. Press + or – until the "Enable" displays.
6. Press ↵ to enable the validator. An asterisk (*) should appear
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
8. Press PAUSE again to put the printer online.
Attach The Power/Data Cable To The Validator
CTRL menu to allow the VALIDATOR menu to appear.
. .
to take the printer offline and place the printer in
.
Menu mode.
↵ key. (This key combination can be changed by the user. Use
the customer's key combination if necessary.)
. .
until "VALIDATOR" displays.
.
after "Enable." Once enabled, the printer will command the
validator to begin scanning and reporting errors, and the
counters will be incremented.
PAUSE to take the printer offline.
27