Printronix T5000e Series Module Manual page 50

Chapter 2
Configuring The Validator
2. If necessary, press ↓ and ↵ at the same time to unlock the
↵ key.
3. If necessary, press
4. Press ↓ until "Quiet Zones" displays.
5. Press + or – to scroll through the choices: Enable or Disable.
The default is Enable.
6. Press ↵ to select the desired value.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
NOTE: The validator does not recognize x-dimensions greater
Checking The Firmware Revision Number
For troubleshooting purposes, you may need to reference the
firmware revision number.
1. Press
Menu mode.
2. If necessary, press ↓ and ↵ at the same time to unlock the
↵ key.
3. If necessary, press
4. Press ↓ until "F/W Revision" displays. The firmware version
number displays.
5. Press ↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
6. Press PAUSE again to put the printer online.
50
. .
until "VALIDATOR" displays.
.
than 40 mil with Quiet Zones enabled.
. .
to take the printer offline and place the printer in
.
. .
until "VALIDATOR" displays.
.