Configuring The Validator; Enabling And Disabling The Validator; Validator Reporting - Printronix T5000e Series Module Manual

Configuring The Validator

Setting validator options is done through the printer configuration
menu. The validator comes equipped with a default setting for each
configuration option, and it works without having to change any of
these options. However, in some cases it is necessary to adjust
these options, which are described below.

Enabling And Disabling The Validator

1. Press
Menu mode.
2. If necessary, press ↓ and ↵ at the same time to unlock the
↵ key.
3. If necessary, press
4. Press ↓ until "Validator Funct." displays.
5. Press + or – until "Enable" displays.
6. Press ↵ to enable the validator. An asterisk (*) should appear
after "Enable." Once enabled, the printer will command the
validator to begin scanning and reporting errors, and the
counters will be incremented.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
NOTE: To disable the validator once it has been enabled, repeat

Validator Reporting

After any completed print job, you can request a report from the
printer which describes the validation statistics since the printer
was turned on, or since the last data reset (for information on
resetting data, see page 45).
Enabling And Disabling The Validator
. .
to take the printer offline and place the printer in
.
. .
until "VALIDATOR" displays.
.
steps 1–8 and select the "Disable" option in step 5.
43