Printronix T5000e Series Module Manual page 44

Chapter 2
Configuring The Validator
Requesting A Validator Report
This procedure prints a summarized validator report on the printer
itself.
1. Press
2. If necessary, press ↓ and ↵ at the same time to unlock the
3. If necessary, press
4. Press ↓ until "Validator Report" displays.
5. Press ↵ to print the report.
6. Press ↓ and ↵ at the same time to lock the ↵ key, then press
7. Press PAUSE again to put the printer online.
Setting Auto Report
This function allows you to disable or enable an automatic validator
report printout after a batch job. The factory default is Disable.
You can determine the end of a batch job in two ways:
•
•
To enable Auto Report:
1. Press
2. If necessary, press ↓ and ↵ at the same time to unlock the
3. If necessary, press
4. Press ↓ until "Auto Report" displays.
5. Press + or – to scroll through the choices: Enable or Disable.
6. When Enable displays, press ↵ to activate Auto Report.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
8. Press PAUSE again to put the printer online.
44
. .
to take the printer offline and place the printer in
.
Menu mode.
↵ key.
. .
until "VALIDATOR" displays.
.
PAUSE to take the printer offline.
by using an Execute command, or
a timeout of more than 10 seconds.
. .
to take the printer offline and place the printer in
.
Menu mode.
↵ key.
. .
until "VALIDATOR" displays.
.
The default is Disable.
PAUSE to take the printer offline.