Chapter 2
Basic Validator Setup
•
RESET: This button is used in the calibration procedure and
possible troubleshooting situations. Except in these specific
circumstances, the RESET button should not be used.
Time RESET Button Is Depressed
Less than 2 seconds
More than 4 but less than 6 seconds
More than 6 seconds
CAUTION
Do not lift the printer by the validator unit or by the lower
bracket.
CAUTION
The validator contains sensitive electronic equipment. Do not
jar or drop the unit.
40
Table 3. RESET Button Settings
Turns on scanning beam
Validator goes into calibration mode
Resets validator to factory calibration and
turns off scanning beam
Result