Leds - HP FlexFabric 5700-48G-4XG-2QSFP+ TAA Installation Manual

Item
Compatible standards
To avoid interference between cables, HP recommends that you layer cables as follows:
Use category-6A or above cables and connectors.
•
• Do not bundle cables in their first 20 m (65.62 ft).
Separate power cables and twisted pair cables at and around the distribution frame.
•
For ports adjacent to one another on the device, the peer ports on the distribution frame is
•
preferably not adjacent, for example:
If the device connects to one distribution frame, connect port 1 on the device to port 1 on the
distribution frame, port 2 on the device to port 3 on the distribution frame, and port 3 on the
device to port 5 on the distribution frame.
If the device connects to two distribution frames, connect port 1 on the device to port 1 on
distribution frame 1, port 2 on the device to port 1 on distribution frame 2, and port 3 on the
device to port 2 on distribution frame 1.

LEDs

System status LED
The system status LED shows the operating status of the switch.
Table 18 System status LED description
LED mark
SYS
SFP+ port LED
Each SFP+ port has a status LED to show port operating status and activities.
Table 19 SFP+ port LED description
LED status
Steady green
Flashing green
Specification
•
IEEE 802.3ab
•
IEEE 802.3an
Status
Steady green
Flashing green
Steady red
Flashing red
Off
Description
A transceiver module or cable has been correctly installed. A link is present, and the port
is operating at 10 Gbps.
The port is sending or receiving data at 10 Gbps.
Description
The switch is operating correctly.
The switch is performing power-on self test (POST).
The system has failed to pass POST or has problems such as
fan failure.
Some ports have failed to pass POST.
The switch is powered off or has failed to start up.
51