Control Panel - ACME XP-1200F User Manual

XP-1200F

4. Control Panel

○
1 Display
To show the various menu and to select functions.
○
2 Button
MENU To select the programming functions
UP To go backward in the selected functions
DOWN To go forward in the selected functions
ENTER To confirm the selected functions
○
3 Power Switch: Turns On/Off the mains power.
○
4 Fuse: Protect the unit from damage of current.
○
5 Power Cable: Connect to mains power.
○
6 DMX input: Connect with dedicate controller for signal input
○
7 DMX input: Connect with usual controller for DMX signal input
○
8 DMX output: Connect with next unit to transmit DMX signal
7-
blink. Use DOWN and UP button to adjust the effect home position. Once the effect has
been selected, press the ENTER button to setup or automatically return to the offset
functions without any change press the MENU button again, To go back to the main
functions without any change after 8 seconds.
Dimmer offset
Press the MENU button for at least 5 seconds into offset mode, use DOWN and UP button
up to when the is shown on the display. Pressing ENTER button and the display will
blink. Use DOWN and UP button to adjust the dimmer home position. Once the effect has
been selected, press the ENTER button to setup or automatically return to the offset
functions without any change press the MENU button again, To go back to the main
functions without any change after 8 seconds.
7. How To Control The Unit
Two ways to operate:
1. By dedicated controller
2. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show 1200 on the
display and move all the motors to their 'home' position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal.
7.1 DMX512 Connection
The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
XP-1200F
12-