Table of Contents
Advertisement
Adjustments by dealer
The correct tension of the chains
Several chains are present on the tricycle These must have enough room for
movement. Without any real effort, the chain must be able to be moved about half a
centimetre up and down.
In order to keep tension on the chain, the rear
wheel axis can be adjusted. Follow the
instructions below:
1. Slightly loosen the nuts on the rear
wheel axis, allowing the rear wheel to
move back and forth.
2. Tighten the nuts on the two chain
tensioners, making the rear wheel move
backwards and tightening the chain. Do
this in such a way that the chain has
some room to move, as previously
indicated.
3. At the same time, make sure the wheel
is straight and located in the middle of
the frame. Not to the left or right. See
figure [A].
4. Lightly tighten the nuts of the rear wheel
axis.
5. Make sure the tension on the chain is
adequate and that the wheel is attached
straight to the frame.
6. Now firmly tighten the nuts.
User manual
VeloPlus3 17.12
1.
[A]
2.
2.
26
Advertisement
Table of Contents
