Advertisement
Quick Links
Advertisement
Related Manuals for Vanraam Balance
Summary of Contents for Vanraam Balance
- Page 1 User manual Balance Van Raam BV Aaltenseweg 56 7051 CM Varsseveld Netherlands 06.13...
- Page 2 Aaltenseweg 56 7051 CM Varsseveld Netherlands Tel. : +31 (0)315 257370 E-mail : info@vanraam.nl Internet : www.vanraam.nl Conformity Van Raam declares as manufacturer that the Tavara Balance bicycle has been produced in accordance with the 93/42/EEG guidelines. User manual Balance 06.13...
- Page 3 Also the local traffic rules should always be complied with. All other use, including damage or physical injuries due to this, are not the manufacturer's responsibility. User manual Balance 06.13...
- Page 4 Make sure that wide trousers or lose hanging clothing don’t get caught in the chain, spokes or pedals. Do not use a pressure washer or a steam cleaner for the cleaning of the bicycle. User manual Balance 06.13...
- Page 5 If an optimal adjustment of the bicycle, as defined in the instructions, is not possible, you can contact your dealer for a fitting solution. The brakes are correctly adjusted as standard and can only be adjusted by the dealer during periodic maintenance. User manual Balance 06.13...
- Page 6 Do not pull out the saddle pin further than the marking. The tube will not go into the shank deep enough and will risk coming off. This can lead to MIN INSERT serious injuries. User manual Balance 06.13...
- Page 7 2. Put the handle bars in the desired position and then tighten the screws considerably. 3. Slightly loosen screw (C) with an Allen key, put the handle bars in the correct (horizontal) position and then tighten the screw again. User manual Balance 06.13...
- Page 8 With the socketed screw (A) the crank shortener should be aligned with the crank. 2 assembly points pedal Eccentric crank The bicycle can be fitted with an eccentric crank on the left and/or right side. User manual Balance 06.13...
- Page 9 Foot support The foot support is fitted to the pedal with a balance block. Flashing light system To use the flashing lights press the switch to left or right. If you want to switch off the flashing light system, put the switch in the middle position.
- Page 10 The engine has launch control. This allows the driver to accelerate without pedaling deAkkus up to a speed of 5 km / h . To accelerate, press the launch button and keep it pressed down . The motor is activated after 2 seconds. User manual Balance 06.13...
- Page 11 Pull the handle forward. Take the battery pack into the house. Plug the charger into the plug contact of the battery. Connect the charger plug into the socket. The red light on the charger will light up. User manual Balance 06.13...
- Page 12 Push the handle forward and close the lock. It is also possible to charge the battery while it is still in the holder. User manual Balance 06.13...
- Page 13 Backup battery (optional) The bike can be supplied with a second battery. To activate the second battery (when the first battery is empty) turn on the switch under the luggage carrier in order to activate the battery. User manual Balance 06.13...
- Page 14 You now can change the 3 AA batteries. In case you can not easily reach the screws, slightly loosen screw [A] and tilt the light a quarter turn, so the screws are better accessible. User manual Balance 06.13...
- Page 15 Technical details Length (cm) Frame height (cm) Boarding height (cm) 24“ Front wheel 24“ Back wheel Weight (kg) Ab 19 Max. load luggage rack (kg) Total max. load (kg) Brakes, front Cantilever brakes Brakes, back Cantilever brakes User manual Balance 06.13...
- Page 16 After 200 kilometres or after a period of 2 months the bicycle should be inspected. Check the brakes, the illumination and the spokes. Also check the tyre tread depth. This should be at least 1 mm. Worn out tyres or possible faulty parts should be replaced. User manual Balance 06.13...
- Page 17 If you still decide you want to replace components yourself, you are responsible for damage or harm due to incorrectly fitted components. Only use original spare parts, which you can buy at you dealer. If requested the dealer will make the necessary information on repair and maintenance available. User manual Balance 06.13...
- Page 18 The guarantee as well as the product liability in general expires if the instructions stated in this manual are not followed. This is also the case if unauthorized maintenance is carried out or if technical changes or additions are made without permission of Van Raam. User manual Balance 06.13...
- Page 19 Frame number The frame number is printed on the sticker. This sticker is located on the frame, see the image below. Example sticker: Frame number Position of sticker: on backside of the saddle tube User manual Balance 06.13...