Brother ADS-2400N User Manual page 142

Scan Using Your Computer
Brightness
Adjust the setting (-50 to 50) to get the best image. The default value of 0 represents an average and
is suitable for most images. Set the Brightness level by dragging the slider to the right or left to lighten
or darken the image. You can also enter a value in the box to set the level. If the scanned image is too
light, set a lower Brightness level and scan the document again. If the image is too dark, set a higher
Brightness level and scan the document again.
Contrast
Adjust the setting (-50 to 50) to get the best image. The default value of 0 represents an average and
is suitable for most images. Increase or decrease the contrast level by moving the slider to the right or
left. An increase emphasizes dark and light areas of the image, while a decrease reveals more details
in gray areas. You can also enter a value in the box to set the Contrast.
NOTE
The Contrast setting is only available when setting Scan Type to Gray (Error Diffusion), True Gray or
24bit Color.
Reduce Noise
You can improve and enhance the quality of your scanned images with this selection. The Reduce
Noise setting is available when using 24bit Color and scan resolutions of 300
or 600 × 600 dpi.
5 2-sided Scanning
Select Long-edge binding or Short-edge binding depending on the layout of your original to make sure
that the data file created appears correctly in the scanned document.
2-sided Scan Setting
Long-edge binding
Short-edge binding
Original Layout
× 300 dpi, 400
Scan Result
6
× 400 dpi
126