Appendix: Putting Profibus Into Operation With A Siemens S5 - Pepperl+Fuchs VAG-PB-KF-R4 Manual

Appendix: Putting Profibus into Operation with a Siemens S5

13 Appendix: Putting Profibus into Operation with a Siemens S5
This chapter shows exemplarily the putting into operation of an AS-i/PROFIBUS
Gateway on Profibus for the PLC Simatic S5 135 of Siemens with the Profibus master
card IM 308 C. The configuration software used is the Siemens COM PROFIBUS 3.0
(German version).
13.1 Putting into Operation in Easy Mode
1. Copy the GSD-file "bwes1742.gsd" (or all GSD-files) from the diskette "AS-i/
PROFIBUS Gateway IBM PC Software" from the directory A:\GSD to the directory
\GSD of the software COM PROFIBUS 3.0.
2. Start the configuration software COM PROFIBUS 3.0
3. Execute the command "File | Scan GSD-Files".
4. Execute the command "File | New".
The dialog box "Master & Host Selection" appears.
Select your Profibus master.
5. With the command "Configure | Master Parameters..." you can select the baudrate
and other bus parameters.
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
AS-i/PROFIBUS Gateway
Copyright Pepperl+Fuchs, Printed in Germany
59