Panasonic KX-TDA600 Installation Manual page 268

3.2 Connection
External Modem Connection
Modem
To RS-232C port (25-pin)
To trunk/Hybrid IP-PBX extension
port assigned as the trunk destination
External Modem (25-pin)
Signal Name
RD (RXD)
SD (TXD)
ER (DTR)
DR (DSR)
After connecting the Hybrid IP-PBX and the external modem, set the power switch of the external modem
to "ON", then the external modem will be initialised with the default values.
The following AT command settings may be required for the modem:
• The Data Terminal Ready (DTR) signal should be ignored.
• The Data Terminal Equipment (DTE)/Modem flow control should be turned off.
• Data compression should be disabled.
• Error Correction is not necessary.
Notes
• Use an RS-232C straight cable for connection between the Hybrid IP-PBX and external modem.
• An AT command (for initialisation, enabling automatic answer, etc.) can only be programmed by
KX-TDA600 Maintenance Console. "AT&F" is stored as the default value.
• For more information about the AT command, refer to the external modem's instructions.
268 Installation Manual
Pin No.
3
2
20
6
WWW.ERTEBATGROUP.COM
RS-232C Port
(9-pin)
Hybrid IP-PBX (9-pin)
Pin No. Signal Name
2 RD (RXD)
3 SD (TXD)
4 ER (DTR)
6 DR (DSR)
WWW.ERTEBATGROUP.COM