Panasonic KX-TDA600 Installation Manual page 252

2.12 Connection of Doorphones, Door Openers, External Sensors, and External Relays
2.
Pass the wires through the hole in the base cover, and attach the base cover to a wall using 2 screws.
Screw
Note
Two kinds of screws are included with a KX-T30865. Please choose the appropriate kind for your wall
type.
: when a doorphone plate has been fixed to the wall
: when you wish to install the doorphone directly onto the wall
3.
Connect the wires to the screws located in the front cover.
4.
Re-attach the 2 halves and re-insert the screw.
Connection
Use 8-pin and 10-pin terminal blocks (included with the card) for connection.
1.
While pressing down on the hole at the top of the terminal block using a screwdriver, insert the wire into
the side hole as shown below. Repeat this procedure for other doorphones, door openers, external
sensors, and external relays.
Refer to "2.8.2 DPH4 Card (KX-TDA0161)", "2.8.3 DPH2 Card (KX-TDA0162)", and "2.8.4 EIO4 Card
(KX-TDA0164)" for pin assignments.
Doorphone
Door Opener
External Sensor/
External Relay Device
252 Installation Manual
To 8-pin terminal block
To 8-pin terminal block
WWW.ERTEBATGROUP.COM
WWW.ERTEBATGROUP.COM