Panasonic KX-TDA600 Installation Manual page 263

WWW.ERTEBATGROUP.COM
2.
Plug the AC power cord into the Hybrid IP-PBX and an AC outlet, and turn on the Hybrid IP-PBX. The
RUN indicator will flash.
Note
For safety reasons, do not stretch, bend, or pinch the AC power cord.
To AC Outlet
3.
While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for the IP-GW
card) will be initialised to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW card will not be initialised.
Note
Use only the AC power cord included with the Hybrid IP-PBX for the PSU.
LED Indications
For the Basic Shelf
Indication
RUN
ALARM
Colour Description
Green PBX status indication
• OFF: Power Off (includes normal reset)
• ON: Power On and running (on-line)
• Flashing (60 times per minute): Starting up
• Flashing (120 times per minute): Starting up or resetting with:
•
•
Red Alarm indication
• OFF: Normal
• ON: Alarm (CPU stop, alarm for each optional service card
installed in the Basic Shelf)
• Flashing: Alarm (MPR file error in restarting)
WWW.ERTEBATGROUP.COM
the System Initialise Switch in "SYSTEM INITIALIZE"
position
the SD Memory Card not inserted
2.15 Starting the Hybrid IP-PBX
Installation Manual 263