Data Exchange Between Paperless Recorder And Pc - JUMO LOGOSCREEN 500 Operating Instructions Manual

5.3 Data exchange between paperless recorder and PC

5.3.1 Data transfer via diskette
➔
PC paperless
recorder
H
H
Paperless
➔
recorder PC
Import/export
errors
H
A
The exchange of configuration data between the recorder and a PC (setup
program) is carried out via a 3.5" diskette, or data transfer using the setup in-
terface.
h Make the settings in the setup program.
h Write the settings to diskette by using the Data transfer
diskette menu, or by activating the
h Insert the diskette into the recorder
(remove the measurement data diskette first, if necessary).
h Call up the Disk manager menu on the recorder.
h Select function Diskette ➔ Config. data and activate
After the configuration has been successfully read in, the recorder will be auto-
matically reset. If the measurement data diskette has been removed, a new
diskette should be inserted.
The measurement data on the diskette will be overwritten
by a new configuration.
Do not use the menu function "File ➔ Save as...".
It cannot be used to create a valid diskette for the recorder.
h Insert diskette into the recorder
h Call up the Disk manager menu on the recorder.
h Select function Config. data
h After a successful transfer, the diskette can be inserted into the PC.
h Using the menu Data transfer
vating the button, the data can be read into the setup program.
If errors during transfer from and to diskette occur on the recorder side, these
will be indicated in the disk manager menu and will remain so until the error
has been rectified or is overwritten with fresh error messages.
A diskette containing configuration data must not
have other files on it.
The diskette has to be formatted before use. It must not contain any data
or faulty sectors. If this is disregarded, a fault-free data exchange cannot
be ensured.
5 Setup program
button.
➔
Diskette and activate
➔
Data import from diskette menu or by acti-
➔
Data export to
.
.
67