Advertisement
6-10
DOORS
Fig. 6-15 —Glass Run Channel Inner - Outer Strip
Assembly Removal - " A - X - Z " Styles
5. To install, position strip assembly so that
tang of clips start into slots in door panel,
then press at each clip location and engage
clips.
Prior to installing strip assembly, reform
clip tangs to assure positive retention when
installed.
NOTE: To make strip assembly removal tool,
make a 1/4" wide by 3/8" deep slot in a
J-2772 headlining inserting tool or equivalent.
SIDE ROOF RAIL WEATHERSTRIP
AND RETAINER
The side roof rail weatherstrip is cemented to a
side roof rail weatherstrip retainer, which, in turn,
is secured with screws to the side roof rail. The
adhesive that retains the weatherstrip also pro-
tects against water entry between the retainer and
weatherstrip. A saturated polyurethane foam seal-
ing strip prevents water entry between the retainer
and side roof rail.
Removal-(AII "17-37-39-57" Styles,
"B-87" Styles and "C-69" Styles)
1. Remove plastic fasteners at front and screw
at rear of side roof rail weatherstrip. On "C-
69" styles, plastic fasteners are used at front
of front door side rail weatherstrip and screw
at rear of rear door side rail weatherstrip
(See Fig. 6-16 for "17-37-39-57" and "B-87"
styles and Fig. 6-17 for "C-69" Styles).
2. While carefully pulling weatherstrip out of re-
tainer, simultaneously break cement bond be-
tween weatherstrip and weatherstrip retainer
using a flat-bladed tool.
PLASTIC
FASTENERS
SECTION A-A
2140
Fig. 6-16-Side Roof Rail Weatherstrip - All "17-37-39-57" Styles and "B-87" Styles
Advertisement
