Advertisement
REAR QUARTER
7-3
3. Lower window to a position shown in Figure
7-16 for "A-07" styles and Figure 7-17 for
"A-11" Styles.
REAR QUARTER W I N D O W
A D J U S T M E N T S - ^ & B" Closed Styles
4. Supporting window with one hand, disengage
clip retainer securing regulator lift arm to
pivot pin on window lower sash channel ("11"
styles) or to lower edge of glass ("07" style).
Lower front edge of glass until nylon guide at
top of window front vertical sash comes out of
front glass channel and rear edge of glass
comes out of rear run channel. Then, lift glass
up (rear edge first) and remove window from
body outboard of window opening.
6. To install, reverse removal procedure.
All window assembly adjustments are provided at
the window regulator attaching screws.
1. To obtain proper seating of the glass in the
upper glass run channels, or proper contact
between belt sealing strips and lower sash
channel, loosen regulator attaching screws and
adjust window as required.
2. To eliminate a fore and aft bind between the
glass run channels (hard operating window), or
a condition where window will not stay in rear
run channel, loosen rear run channel attaching
bolt and adjust run channel fore or aft as
required.
Fig. 7-^-Rear Quarter Hardware - " A - 0 7 " Style
1. Glass Retainer
2. Glass Run Channel
3. Window Regulator (Manual)
4. Window Regulator (Electric)
Advertisement
