Advertisement
FRONT END
5-9
front compartment lid. This double-ended tool is
designed with a different end for right and left side
of body.
Removal and Installation
1. Install protective covering over compartment
lid and lower part of windshield.
2. Open compartment lid and prop same in a full
open position.
3. Remove windshield wiper arms.
4. Remove shroud top air intake grille.
5. Remove torque rod clamp to shroud, located to
right of center of shroud (Fig. 5-19).
6. Install tool J 21928 (Fig. 5-19) to lid torque
rod on right side of body. Securely grasp tool
and move it toward windshield to disengage
rod from retaining notch. Carefully disengage
tool from rod.
7. In like manner remove rod on left side of body
(Fig. 5-20).
V.ToTOU
AND SCREWS
30° NOTCH _
FOR RIGHT SID
MOVE TOOL TOWAR
GLASS TO REMOVE ROD
90° NOTCH
FOR LEFT SIDE
Fig. 5-19—Torque Rod Removal - Right Side
Fig. 5-20—Torque Rod Removal - Left Side
NOTE:
Front compartment lid hinge assembly
removal should be made only after torque rods
are removed.
8. To install, apply a coat of No. 630AAW Lubri-
plate or equivalent to torque rod end that con-
tacts hinge
roller and reverse . removal
procedure, locating torque rods in the same
notch in retainer as they were before removal.
Check tension on lid. If additional tension is
required reset torque rod.
FRONT COMPARTMENT LID LOCK
CYLINDER ASSEMBLY
The front compartment lid lock cylinder is attached
to the front end panel molding which is secured to
the front end panel by studs and nuts. (See Fig.
5-21)
Removal and Installation
1. Remove front end panel molding assembly as
explained in the "Exterior Molding" section of
this manual (See index).
Advertisement
