Advertisement
15-18
SEATS
TABS
SEAT CUSHION SPRING
H O G R I N G S
Fig. 15-16 —Seat Cushion-to-Back Spring Attachment
SEAT BACK ASSEMBLY-(Right or L e f t ) -
Two Door Style with Standard Full Width Seat
Removal and Installation
1. a. On seat with seat cushion side panel, re-
move side panel and detach seat cushion
trim sufficiently to expose outer hinge pin
and retainer.
b. On seats with outer hinge arm cover, re-
move screw securing cover and remove
cover.
2. Using a flat bladed tool carefully remove re-
tainer securing seat back outer arm to hinge
pin.
3. Carefully disengage seat back outer arm from
hinge pin; then, tilt seat back forward and up-
ward to disengage seat back inner arm from
hinge pin and remove seat back from body.
4. To install seat back assembly, reverse re-
moval procedure making sure washers are in-
stalled over hinge pins prior to installing seat
back. If outer retainer is damaged, install new
retainer.
FRONT SEAT BACK ASSEMBLY
(RIGHT OR LEFT)-"A" Body " 3 9 " Style
Full Width Seat with Center Arm Rest
Removal and Installation
1. Remove front seat assembly from body and
place upside down on a clean protected surface.
Remove seat cushion side panels.
2. Remove hog rings securing lower edge of seat
cushion trim bottom facing to seat cushion
springs and frame (Fig. 15-18).
3. Remove outer hinge arm cover (Fig. 15-18);
then, using a flat bladed tool carefully remove
retainer securing seat back outer arm to hinge
pin (Fig. 15-18).
Fig. 15-18 —Seat Back Removal (Right or Left)
23739, 33839 and 44439 Styles
Fig. 15-17 —Seat Back Attachment
Hog Rings Securing
Seat Cushion Trim
Bottom Facing
Seat Back Outer
Arm Cover
Seat Back Outer
Arm Retainer
4. Seat Back Outer
Arm Cover Fastener
5. Seat Back Attaching
Bolt Access Hole
6. Seat Back Frame to
Seat Cushion Frame
Attaching Bolts
Advertisement
