Advertisement
DOORS
6-63
VENTILATOR LOWER
FRAME BOLT
DOOR INNER PANEL
TO VENTILATOR
SCREW
VENTILATOR LOWER FRAME
ADJUSTING STUD & NUT ~
VENTILATOR DIVISION
CHANNEL LOWERSSL- ""1054
ADJUSTING STUD & NUT
Fig. 6-86 — Front Door Ventilator Attachments -
" Z " Styles
FRONT DOOR WINDOW
ADJUSTMENTS-"X-37" Styles
1. To adjust the window in or out or fore or aft at
front section, lower door window and loosen
ventilator division channel lower adjusting stud
and nut. Turn adjusting stud in or out or posi-
tion lower end of channel fore or aft as r e -
quired and tighten stud nut.
2. To adjust the window in or out at rear section,
loosen rear run channel lower attaching nut.
Adjust channel as required, and tighten nut.
3. Up or down adjustment is available at the
lower stop assembly and additionally at the
up-travel stops.
FRONT DOOR WINDOW ASSEMBLY-
All "Z" Body Styles
The front door window assembly consists of a
frameless
piece of solid tempered safety plate
glass pressed into a thin-section lower sash chan-
nel. When cycled, the glass operates within the
ventilator division run channel and the window rear
run channel. Guide plates welded to the front and
rear of the sash channel also operate in the run
channels and give stability to the glass in the full up
position.
NOTE:
Because these guide plates are not ad-
justable, it is imperative that replacement door
glasses be installed flush with the guide plates at
the front and rear of the glass. If glass is too far
forward or rearward in relation to guide plates,
window assembly will be tight within the run
channels.
CAUTION:
Handle glass with care. Edge chips
can cause solid tempered safety plate glass to
shatter. Do not attempt to grind glass.
Removal and Installation
1. Remove door trim assembly and detach inner
panel water deflector. Operate window to an
almost full-up position.
2. Working through front and rear upper access
holes, remove bolts securing front and rear
up-travel stops to lower sash channel and r e -
move stops.
3. Lower glass to approximately 3" down from
full-up position and remove lower sash chan-
nel cam attaching screws.
4. Supporting glass with one hand, disengage cam
from
regulator
rollers
and
remove cam.
Lower glass to door bottom.
5. Remove both inner and outer strip assemblies
at belt as described under "Glass Run Channel
Inner and Outer Strip Assemblies".
6. Loosen ventilator attaching screws and ad-
justing stud nuts at points described below and
illustrated in Figure 6-86.
a. Ventilator division channel lower adjusting
stud nut.
b. Door inner panel to ventilator attaching
screw.
c. Ventilator adjusting stud nut and ventilator
attaching bolt located on door hinge pillar.
7. Lift window assembly and remove it from bet-
ween door panels at belt line.
8. To install, reverse removal procedure. Adjust
window as described below. Adjust ventilator
as described under "Front Door Ventilator
Adjustments".
Advertisement
