Advertisement
14-10
DOOR, QUARTER AND SHELF TRIM
2. Push tool to disengage handle spring from
spindle and remove bearing plate and handle
from quarter trim.
3. To install, engage retaining spring on handle
and position handle at same angle as opposite
side quarter window handle; then press handle
until spring engages spindle.
REAR QUARTER ARM REST
There are three types of arm rests utilized on all
body types:
A. Applied arm rests which are retained by two
screws inserted through the arm rest base into
the quarter inner panel (Fig. 14-19).
B. Floor mounted arm rests which are retained by
screws inserted through the arm rest assembly
into prescribed brackets (Fig. 14-20).
NOTE:
When this type of arm rest is utilized
on convertible styles (except " F " Bodies) it is
removed as an assembly with the folding top
compartment side trim panel (Fig. 14-21). On
"F" Body convertibles, the arm rest i s re-
moved with the folding top compartment side
trim panel and quarter trim pad as an assembly.
C. Arm rests which are an integral part of the
quarter trim and are removed as an assembly,
appear on all Cadillac " E " Bodies and on
certain "F" Body styles.
Removal and Installation
1. On styles equipped with applied arm rest, re-
move two screws in arm rest base and remove
arm rest from trim pad.
2. On styles equipped with floor mounted arm
rest, perform the following:
TRIM (FOLD OVER & CEMENT)
LOCK PILLAR
INNER STRIP
END PLATE
2537
VIEWG
(37 STYLES ONLY)
VIEW F
(37 STYLES ONLY)
Fig. 14-19—Rear Quarter Trim Assembly (Insert Type)
Advertisement
