TAIL GATE
9-13
TAIL GATE W I N D O W
UPPER GLASS RUN CHANNEL
"B & A " BODY STYLES
Removal and Installation
1. Open tail gate. With finger pressure only,
squeeze run channel at one end and pull channel
out of retainer.
2. Once run channel has been removed, the re-
tainer attaching screws are exposed. (See Fig.
9-25). The retainer can be adjusted by loosen-
ing attaching screws, shifting retainer to de-
sired
position
and
tightening
screws.
If
retainer is removed, seal same with medium
bodied sealer prior to installation.
3. To install, reverse removal procedure.
Fig. 9-25—Tail Gate Upper Glass Run Channel Retention
SIDE REVEAL MOLDING
UPPER REVEAL MOLDING-
GLASS RUN CHANNEL
GLASS RUN CHANNEL RETAINER
SEALER
SECTION A-A
SEALER
SECTION B-B
2070
Fig. 9-26 —Tail Gate Opening Sealing - " X " Body Styles