Advertisement
SEATS
15-25
INNER ADJUSTER
NUTS
OUTER ADJUSTER
BOLTS
Fig. 15-28-Four-Way Bucket Seat Floor Pan
Attachment - "B & C " Styles
3. Remove seat adjuster-to-floor pan rear at-
taching bolts (Figs. 15-26 and 15-28).
4. Operate seat to full rearward position. Remove
seat adjuster-to-floor pan front attaching bolts
(Fig. 15-26 and 15-28). Tilt seat rearward
sufficiently to disconnect seat harness feed
connector and detach harness from clip on
floor pan; then remove seat assembly from
body.
5. To install, reverse removal procedure. Make
sure ground wire is secured under adjuster
inboard rear attaching nut or bolt. Check
operation of seat adjusters to full limits of
travel. On "A" Body Styles make sure floor
carpet is properly positioned around rear sup-
ports of adjuster prior to installing carpet
retainer on adjuster stud and adjuster rear
attaching nuts.
PASSENGERS FRONT BUCKET SEAT
BACK STOP CABLE OR SPRING-
"F" Body Styles
Removal and Installation
1. Using a flat bladed tool inserted between pas-
sengers seat back outer hinge arm cover and
hinge arm, carefully disengage upper portion of
cover from fastener and remove cover from
outer hinge arm (Fig. 15-29).
2. At outer
side
of passengers
bucket seat
cushion, remove screw securing seat back stop
cable
and trim protector washer to seat
cushion frame (Fig. 15-29).
3. Remove bolt securing seat back stop cable and
spring to seat back outer hinge arm (Fig. 15-
29) and remove cable and spring from seat.
4. To install seat back stop cable or spring,
reverse
removal
procedure.
Make certain
spring is engaged with stop cable and seat
back hinge arm, as shown in Fig. 15-29).
FRONT BUCKET SEAT BACK ASSEMBLY
(RIGHT OR LEFT)-Standard Bucket S e a t -
"F and Z " Styles
Removal and Installation
1. Remove front seat assembly as previously
described.
2. Using a flat bladed tool inserted between seat
back hinge arm and hinge arm cover, care-
fully disengage upper portion of cover from
fastener and remove cover from both inner and
outer hinge arms (See Fig. 15-29). If re-
moving passengers seat back on " F " Styles
remove screw securing seat back stop cable
and trim protector washer to seat cushion
frame (Fig. 15-29).
3. Carefully disengage and remove retainer s e -
curing both inner and outer hinge arms to seat
cushion hinge pins (Fig. 15-29).
HINGE ARM
COVER
Fig. 15-29 —Seat Back and Cable Stop
Advertisement
