Advertisement
DOORS
6-99
FRONT A N D REAR UP
TRAVEL STOP SCREWS
FRONT
GUIDE^LOWER
ADJUSTING
STUD NUT
I
INNER PANEL
C A M SCREWS
LOWER
SASH
CHANNEL
C A M
REAR SCREW
REAR GUIDE LOWER
ADJUSTING STUD NUT
0 5 0
Fig. 6-127 —Rear Door Hardware - " Z - 3 9 " Styles
4. Pull stationary ventilator window forward and
remove from door.
5. To install, reverse removal procedure.
REAR DOOR W I N D O W ASSEMBLY-
" A - 3 9 " Styles
Removal and Installation
1. Raise door window, remove trim pad and de-
tach inner panel water deflector.
2. On styles not equipped with a hang-on door
trim pad, remove inner and outer belt seal
(draft strip).
3. Remove front and rear glass up-stops and win-
dow lower sash channel cam.
4. Pull rear door glass straight up and remove
assembly from door (see Fig. 6-132).
NOTE:
The window regulator lift and balance
arms are designed with a slight outboard
spring. When removing glass, pull regulator
arms toward inner panel to ease removal
procedure. If necessary, the front and rear
guides can be loosened at upper attaching
points (see Fig. 6-132).
REAR DOOR W I N D O W ASSEMBLY-
AM Closed Styles
The rear door window assembly consists of a
frameless solid tempered safety plate glass window
and a press-on lower sash channel assembly.
When handling window, make certain glass does not
develop edge chips or deep scratches which could
cause solid safety plate glass to shatter.
Removal and Installation
("A-35-55-65 and 69" Styles)
1. Lower door window, remove door trim pad
and detach inner panel water deflector.
2. Remove
inner
panel
cam.
On styles not
equipped with a hang-on trim pad, remove
inner belt seal (draft strip).
3. Rotate rear edge of glass downward until front
edge is free of door upper frame and lower
sash channel cam slides off regulator balance
arm roller.
4. Rotate glass upward and forward to disengage
lower sash channel cam from regulator lift
arm roller and remove door window outboard
of door upper frame (See Fig. 6-131, View
"A" and "B").
5. To install, reverse removal procedure.
Adjustments
The up-travel stops can be adjusted to control
height of door glass; the inner panel cam is adjust-
able at the rear attaching bolt to correct a rotated
window; the upper attaching bolts of front and rear
guides provide fore or aft and in or out movement
of glass. The lower adjusting studs can be posi-
tioned to tip the window inboard or outboard at top
edge of glass to maintain proper seal and to ease
window operation (see Fig. 6-132).
FRONT GUIDE
UPPER BOLT
REAR GUIDE
UPPER BOLT
FRONT GUIDE
LOWER
ADJUSTING
STUD & NUT
LOWER SASH
CHANNEL
CAM
FRONT SCREW
REAR GUIDE [j
LOWER ADJUSTING
STUD & NUT
5. To install, reverse removal procedure.
Fig. 6-128-Rear Door Hardware - " Z - 3 9 " Styles
Advertisement
