Advertisement
14-24
DOOR, QUARTER AND SHELF TRIM
REAR QUARTER FRONT TRIM PANEL-
Chevy II Station Wagons
Removal and Installation
1. Remove front screw on rear quarter rear trim
panel. Disengage pinchweld finishing strip from
rear body lower lock pillar pinchweld flange.
Remove rear door sill plate extension.
2. Carefully break cement bond between over-
lapping edge of front trim panel and pinchweld
flange.
Remove front trim panel attaching
screws and remove trim panel from body.
3. To install, reverse removal procedure. Prior
to installation, apply trim cement to pinch-
weld flange surface contacted by overlapping
edge
of
t r i m
assembly
to assure good
retention.
REAR QUARTER WHEELHOUSE TRIM
COVER-Chevy II Station Wagons
Removal and Installation
1. Remove second folding seat back filler panel.
Remove the rear quarter front and rear trim
panels.
2. Remove screws securing second folding seat
back retainer and support and remove retainer
and support from wheelhouse.
3. Carefully break cement bond between wheel-
house trim cover and wheelhouse panel and
remove trim cover from body.
4. To install, reverse removal procedure. Prior
to installing wheelhouse trim cover, apply
neoprene type weatherstrip adhesive, 2" wide,
completely around inside perimeter of wheel-
house trim cover. Also, apply weatherstrip
adhesive to area around cut-out for second
seat back support on wheelhouse. Position trim
assembly to wheelhouse and apply, working
material
down
and outwards to remove
wrinkles.
Install previously removed parts.
SIDE PANEI
SCREWS
-
/ 1
RETAINER
SCREW
1
1
i
E"
/
1
il
1
s
CENTER PANEL -
FRONT RETAINER —i
VIEW " D
1
T
/ r
SIDE PANEL
1
VIEW " E "
1
CENTER
t - 3
PANEL " ^ C ; _ - . * r -
SIDE PANEL J
^
^
&
VIEW "B
1
c
^ ^ ^ f e /
CENTER PANEL
A / >
STUD AND NUT
SECTION " A - A "
CENTER PANEL
REAR RETAINER
> !
^ w ^
2305
VIEW " C "
Fig. 14-39-Typical
M
E " Style Compartment Shelf Trim (Buick " E " Body Shown)
Advertisement
