Icom IC-F5360D Operating Instructions Manual page 60

8
NXDN OPERATION <CONVENTIONAL MODE>
Transmitting a call
D Group call
When you select the NXDN Conventional System zone,
you can make a Group call by using the Group Call
function.
Set GID to "ALL," to call all transceivers.
Push [Group (NXDN)] to enter the GID Select mode.
q
• Displays "SELCALL."
SELCALL
GID 0001
Push [P2]( Ω) or [P3](≈) to select the desired GID.
w
Push [PTT] to make a Group call.
e
Push [P1](EXIT).
r
For your reference:
When [Group + SDM (NXDN)] or [Group + Status
(NXDN)] is assigned, you can send a message along
with a Group call.
To send a Short Data Message with a Group call.
Push [Group + SDM (NXDN)] to enter the GID Se-
q
lect mode.
• Displays "SELCALL."
Push [UP] or [DOWN] to select a desired GID.
w
Push [P1](ENT).
e
• Enters the Short Data Message Entry mode.
Push [UP] or [DOWN] to enter a character, and then
r
push [P1](SET) to set.
• Goes to the next character entry position.
• You can use the 10-keypad keys on the microphone.
Repeat step r until you enter a message of up to
t
100 characters.
• Push [P0](DEL) to delete a character.
• Push [P2](Ω) or [P3](≈) left or right to select a charac-
ter.
SHORT MESSAG
Push [PTT] to send the message to the selected
y
GID.
Push [P1](EXIT) to exit.
u
To send a Status Message with a Group call.
Push [Group + Status (NXDN)] to enter the GID Se-
q
lect mode.
• Displays "SELCALL."
Push [UP] or [DOWN] to select a desired GID.
w
Push [P1](ENT).
e
• Enters the Status Message Entry mode.
Push [UP] or [DOWN] to select a desired status
r
message.
• If you want to directly enter a status message, push [P2]
(MODE) to select the Status Message Entry mode.
You can enter a status message between 1 and 207.
• You can use the 10-keypad keys on the microphone.
STATUS
STATUS 001
Push [P3](TX) or [PTT] to send the message to the
t
selected GID.
Push [P1](EXIT) to exit.
y
8-3