Turning Power On - Icom IC-F5360D Operating Instructions Manual

2
BASIC OPERATION

Turning power ON

Hold down [ ] for 1 second to turn ON the power.
➥
D Adjusting the audio level
When receiving a call, rotate [VOL] to adjust the au-
➥
dio output volume level.
D Inputting the password
If the transceiver is preset for a start up password, en-
ter the digit codes.
While in the Password Entry mode, "PASSWORD"
q
is displayed.
Push [UP] or [DOWN] to enter a digit code, and then
w
push [P1] to set.
• Goes to the next digit entry position.
Repeat step w until you enter the password, and
e
then push [P1].
When using the DTMF microphone:
Push the [0] to [9] digit keys on the microphone to enter
the password, and then push [#].
NOTE: If "PASSWORD" does not disappear after
pushing [P1], the password code you entered may
be incorrect. In this case, enter the correct pass-
word.
For your reference:
When [Transceiver Password] is assigned to any key,
or the Transceiver Password item is preset in the
Menu screen and [Menu] is assigned to any key, the
start up password does not appear, even if the Trans-
ceiver Password is programmed.
In this case, push [Transceiver Password], or select
"Transceiver Password" in the Menu screen to enter
the Password Entry mode, then enter the password
as described above.
[VOL]
[P1]
PASSWORD
Channel 1
2-2
[ ]
[UP] [DOWN]
12345