Table of Contents
Advertisement
b
Connect the other end of the power cord into a three-hole grounded
outlet or UPS power system. A UPS is highly recommended.
c
Repeat steps 4(a) and 4(b) for the other power cord.
5
Repeat the above steps for each additional storage system enclosure you will
be installing.
This completes the physical hardware installation.
Before You Continue...
The the next section, Operating Mode Configuration and Cabling, includes steps
and diagrams for setting the SES Controller card switches, Host I/O card switches
and attaching the required Fibre Channel data cables for configuration. Locate the
applicable operating mode topology and follow the steps and diagrams provided.
In the last section of this chapter are the steps to properly power on or power off
your storage system.
Special Note for Microsoft Windows 2000 Installations
At startup you will see the "Found New Hardware Wizard" appear. Although a
driver is not required for the storage system, a driver .inf file is provided on the
Software/Documentation Disc which can be installed to satisfy this requirement.
Refer to the ReadMe file located in the Drivers directory on the Software/
Documentation Disc for instructions, then follow the on screen wizard to
complete the driver installation.
Chapter 3 - Setup and Installation
Before You Continue...
51
Advertisement
Table of Contents
