Fujitsu IRF-1S series User Manual page 117

b Connect another data cable from the "P2" connector on the lower Disk
I/O card installed in the primary RAID enclosure to the "P1" connector
on the upper Disk I/O card in the daisy-chain enclosure.
CAUTION: When using dual loop topologies, you will be required to install
and use volume management software.
Host Computer Node B
Switch 1
Power Power
Supply Supply
imageRAID IRF-2Sxx-xx/IRF-2Dxx-xx
Power Power
Supply Supply
imageRAID IRF-JBOD
Multi-Port Mirrored SAN Attach-Dual Switch Connection Cabling Diagram (Daisy-Chain)
12 Repeat steps 8 through 11 for each additional daisy-chained enclosure.
13 Power on your system, refer to "Powering On the Storage System" on
page 107.
This completes the setup and cabling of this configuration.
FC HBA FC HBA
Connect H0
DISK I/O
P1 P2
Cooling
DISK I/O
P1 P2
Fans
SES
RS-232
Accesses Loop 0
Connect to P1
Drive Slots 1-12
DISK I/O
P1 P2
Cooling
DISK I/O
P1 P2
Fans
SES
RS-232
Multi-Port Mirrored SAN Attach-Dual Switch Configuration
Chapter 3 - Setup and Installation
FC HBA FC HBA
Host Computer Node A
Switch 2
Connect H1
H0
H0 H1 H1
RAID Controller
RAID Controller
Accesses Loop 1
Drive Slots 1-12
Connect to P1
105