One-Touch Annunciation Configuration Display - Fujitsu IRF-1S series User Manual

Imageraid series

Table of Contents

One-Touch Annunciation Conﬁguration Display

The "One-Touch Annunciation" Conﬁguration Display feature is an easily

accessible press-to-touch display of the SES Controller card switches 1 through 3

settings, the fan speed control setting, Host I/O card and Disk I/O card bus speed

modes, presence of Disk I/O cards, Host I/O cards, and RAID Controllers.

By pressing and holding the Alarm Reset button, the Drive Activity LEDs will all

be extinguished and the Drive Status LEDs will illuminate in unique combinations

to indicate the settings and conditions. Below is an illustration and a table that

describes the Drive Status LEDs and their meanings:

Lt Host I/O

Rt Host I/O

Card Present

Disk I/O Mode

Host I/O Mode

1Gb/2Gb

SES Switch

AD0 Position

AD1 Position

Slot 1

SES Switch AD0

LED On = Up Position

LED Off = Down Position

Slot 2

Host I/O Cards 1 Gb/2 Gb Mode

LED On = 2Gb Mode

LED Off = 1Gb Mode

Slot 3

Right Host I/O Card Present

LED On = Present

LED Off = Missing

Note: Both Host I/O cards must be set to the same mode setting, otherwise the LED will indicate 1 Gb mode, this also applies to the Disk I/O cards.

Lower CNTRL

Present

Upper Disk I/O

Card Present

SES Switch

AD2 Position

Status LED Call-Outs