Fujitsu IRF-1S series User Manual page 78

Chapter 3 - Setup and Installation
3
4
5
66
Stand-Alone Dual Port Dual Host Single Connection Configuration
Locate the switches on the SES Controller card and set them as indicated in
the illustration below. Refer to "SES Controller Card Switch Setting Overview"
on page 52 for the other available settings.
Switch Settings
S
A A A S B D R
P
D D D P D L M
0
0 1 2 1 R Y T
UP (1)
1 2 3 4 5 6 7 8
DOWN (0)
Set the switches 1, 2, and 4 to the "Up" position on the Host I/O cards.
Loosen the two captive fastener screws for a Host I/O card and pull it from
the enclosure using the fastener screws. Set the switches as described in the
illustrations below. Refer to the "Host I/O Card" on page 11 for switch setting
details.
Re-install the Host I/O card. Repeat step 4 for the second Host I/O card.
UP (1)
1 2 3 4 5 6 7 8
DOWN (0)
FC Host Ports
Link Status LED
2 Gb/1 Gb Mode LED
IDs Assigned to Disk Slots
Slot 1 Slot 4
ID 0
ID 2
Slot 2 Slot 5
ID 3
ID 1
Slot 3 Slot 6
ID 9
ID 8
SES Controller Card Switch Settings
Switch
1 HOST SPEED
2 CTRL MODE
3 HUB FAILOVER
4 HOST H0H1 LINK
5 CTRL0 P0P1 LINK
6 DUAL ACTIVE
7
8
Host I/O Card and Switch Settings
Slot 7 Slot 10
ID 4
ID 6
Slot 8 Slot 11
ID 7
ID 5
Slot 9 Slot 12
ID 11
ID 10
Switch Settings
Function
Name
UP (ON) DOWN (OFF)
1G/2G 2 Gb 1 Gb
DIS/ENA imageRAID Not Used
DIS/ENA Enabled Disabled
DIS/ENA Enabled Disabled
DIS/ENA Not Used Not Used
DIS/ENA Enabled Disabled
GND/VCC Not Used Not Used
GND/VCC Not Used Not Used