Table of Contents
Advertisement
Chapter 3 - Setup and Installation
6
7
8
98
Multi-Port Mirrored SAN Attach-Single Switch Configuration
Connect the Fibre Channel data cable(s).
a
Connect your host(s) to the switch.
b
Connect a data cable from a switch port to the "H0" connector on the
right Host I/O card.
c
Connect a data cable from another switch port to the "H1" connector on
the right Host I/O card.
d
Connect a data cable from another switch port to the "H0" connector on
the left Host I/O card.
e
Connect a data cable from another switch port to the "H1" connector on
the left Host I/O card.
Host Computer Node B
Switch/Hub
Connect H0
Power
Power
Supply
Supply
imageRAID IRF-2Sxx-xx/IRF-2Dxx-xx
Multi-Port Mirrored SAN Attach-Single Switch Connection Cabling Diagram
If you wish to add additional enclosure(s), follow the instructions below.
Otherwise skip to step 13. The example depicts one extra enclosure being
added, however, you may wish to add more enclosures up to the allowable
limit of 96 drives.
Set the jumper (JP4) on the Disk I/O card installed in the expansion enclosure.
FC HBA
FC HBA
DISK I/O
P1
P2
Cooling
DISK I/O
P1
P2
Fans
SES
RS-232
Host Computer Node A
Connect H1
H0
H1
H0
H1
RAID Controller
RAID Controller
Advertisement
Table of Contents
